New mounting hardware from D-tek for fuzion...

[Talonman]

Sure!

[Snyxxx]

Thanks. I noticed that the springs on the pro-mount do not look like they are very compressed. Does it feel like there is adequate pressure on the CPU and tight?

[Xilikon]

Thanks. I noticed that the springs on the pro-mount do not look like they are very compressed. Does it feel like there is adequate pressure on the CPU and tight?

The springs on the pro mount is much stronger than the springs on the standard mount. I think it's giving enough pressure but only a test will show this. I'm awaiting for NCIX to get them back in stock and I'll order one myself.

[Talonman]

System is up and running! I has some stability issues until I took one of my presious 2GB memory sticks out. Now I have just successfully MemTested on my last 2GB for a few hours (Memtest to 447% with 0 errors).

I just downloaded Coretemp, and it is reporting these temps at idle:
Core #0 21C
Core #1: 21C
Core #2: 17C
Core #3: 21C

Room temp is currently 63.1F or 17.2C

Core #2 is a bit lower than the rest. Do you think I need to change anything, or is that probably about the norm?

[Talonman]

I am starting to think the chip may just read low temps on the 1 core, by an internal malfunction?

Now Coretemp is reporting this:

Core #0 20C
Core #1: 20C
Core #2: 14C
Core #3: 20C

Room temp is currently 62.2F or 16.7C.

CPU still at stock speed.

Only thing running on the System is formatting my 750GB drive, and Internet Explorer.