2 problems..........


1. If I run a 1:2 ratio on my ram I can run a 9 or 9.5 x multi and get to around or above 270 fsb and around a 2.6ghz clocks speed.

2. If i run 1:1.66 (I think the lower on not higher) I can't run a 9x at all hardly without bios hang, and I can get about 261x9.5 (262 want load and anything higher forget it) and it will error out in prime in less then a min. SO with this ram divider the max cpu clock I can get is about 2.45ghz.


All other setting stay the same. I don't get this if the ram is at ddr2 1000+ it runs fine if I try to drop the muilt to get it to around the ram specs the cpu has issues can anyone verify this?






I don't want to shot 2.3vddim into my ram to max out the board/cpu but this looks like my only option atm ( i do have another set )