Not knowing there was a topic about bowing the MC-TDX I bowed my own (standard, not MC) TDX.
It wasn't my intention at first because I just wanted to get rid of the foam-like bushing between the fitting and the accelerator nozzle.
I had a couple of spare accelerator nozzles so I just modified one to stack on top of the other. The modified nozzle is the replacement of the foam-like bushing.

Some pictures to give you a clue whats going on:


When stacked on top of each other its just as high as the copper block, so when the Lucite top is screwed on, the nozzles are loose (not secure).
I took a piece of neoprene/foam and cut it the roughly the same shape as the modified accelerator nozzle and placed it on top. (sorry, no picture from that).
When I then screwed the lucite top on, the base of the TDX suddenly got bowed .

Some pictures:


Temps just dropped like 3~6C Idle and Load !!