Quote Originally Posted by [XC] DragonOrta View Post
Martin, would you say that a D-Tek nozzle would fit in the MC-TDX, maybe by just dropping it down the inlet barb?
The outside circumference of the D-Tek nozzle is 9.75mm and the ID of a Danger Den barb is 10.12mm so it wobbles around quit a bit inside and would let water flow around the nozzle but if you swapped the Danger Den Barbs to EK with an ID of 9.85mm it fits much better though not perfect, plus you will be relying on the water flow to keep it in place.

Worth a go though!