Quote Originally Posted by coolmiester View Post
The outside circumference of the D-Tek nozzle is 9.75mm and the ID of a Danger Den barb is 10.12mm so it wobbles around quit a bit inside and would let water flow around the nozzle but if you swapped the Danger Den Barbs to EK with an ID of 9.85mm it fits much better though not perfect, plus you will be relying on the water flow to keep it in place.

Worth a go though!
Good idea. I think I'll try that too.

I also thought about taking some heat shrink tubing and shrinking a short section over the outside of the D-tek nozzle to add some diameter to it. That might make it nice and snug.