!!FOUND: Source of G3/8 BSP 1/2" ID metal thermochill barbs & shroud!!

[003]

Nice barbs indeed... try putting Tygon 3/8 over those

I take it you are being sarcastic by insinuating that they are the very small "1/2" barbs that are being sold on NCIX. They are not. I know this because,

1. you can tell by comparing the pictures.

ncix:


gam:

(the top view in the upper right is the giveaway)

2. I have the small barbs from NCIX right here sitting on my desk. Just by comparing them to the pictures on GAM, you can easily tell the shaft is wider on the ones pictured at gam (based on how far a point on the circumference of the shaft is from a point on the perimeter of the hex nut that is perpendicular to a tangent drawn on the original point on the circumference of the shaft).

No worries. Unless the pictures are wrong, these are the real deal.