Water cooling the Asus Maximus SE X38

[Creek Tha Gray]

Thanks for the info....
__________________________________________________ ________________________________
A recap of the 'Confirmed block fit list' for the Maximus SE:

CPU - D-TEK FuZion, Swiftech GTX,
Use XXXXXX to attach the block to the chip.

PWM's - EK X38 Block (T - 10 days), or (ASUS 3 mosfet block with mod) http://www.watercoolinguk.co.uk/foru...pic.php?t=1570
Use AS-Ceramique to attach the block to the chip.

North Bridge - DangerDen Maze4, Swiftech MCW30, EK X38 NB Block (T - 10 days),
Use XXXXXX to attach the block to the chip.

South Bridge - Non existant pre-made block for X38, Ramsinks,
Use XXXXXX to attach the ramsinks to the chip.

FYI - The hole spacings: X38 hole spacing is 64.43mm, ICH9R SB is 55.64mm, Mosfet is 84.71mm.
__________________________________________________ ________________________________

Please correct if any inaccuracies/additions and re-post.
If you know the best thermal compound/type to attach each one, please fill it in.

for the sb swittech mcw30 has a rang of Thru-motherboard installation (two-hole mount) with slotted brackets provide a range from 2.08" (53mm) to 2.36" (60mm) but how would it fit on the nb then do you have to force it or tilt the screws?