Results 1 to 25 of 5439

Thread: **Official DFI LanParty UT P35-T2R Review/Overclock/Guide Thread**

Threaded View

  1. #10
    Xtreme Member
    Join Date
    Aug 2006
    Location
    Adelaide, Australia
    Posts
    298
    I'm getting there...

    I did an 8 hour prime95 v2.54 large fft run with my G0 Q6600 L725A903 @ 450x8. I brought the CPU VTT voltage down to a level I'm more comfortable with. I found that it's all in the GTL's. At first I was trying using the 67% rule, but after bumping them up progressively (leaving everything else the same), I went from a few minutes before failing large fft to eventually settling on 116/116/117, which allowed the 8 hours without failing.

    8x450fsb with Tuniq Tower 120 and a TT 12cm fan at max speed over the NB/PWM area.



    Bios settings:

    CPU Feature
    - Thermal Management Control: Disabled
    - PPM(EIST) Mode: Disabled
    - Limit CPUID MaxVal: Disabled
    - CIE Function: Disabled
    - Execute Disable Bit: Disabled
    - Virtualization Technology: Disabled
    - Core Multi-Processing: Enabled

    Exist Setup Shutdown: Mode 2
    CLOCK VC0 divider: AUTO
    CPU Clock Ratio Unlock: Enabled
    CPU Clock Ratio: 8
    - Target CPU Clock: 3600mhz
    CPU Clock: 450mhz
    Boot Up Clock: Auto
    DRAM Speed: 333/667
    - Target DRAM Speed: DDR2 901
    PCIE Clock: 100mhz

    Voltage Settings
    CPU VID Control: 1.40625v
    CPU VID Special Add: Auto
    DRAM Voltage Control: 2.19v
    SB 1.05V Voltage: 1.150v
    SB Core/CPU PLL Voltage: 1.75v
    NB Core Voltage: 1.57v
    CPU VTT Voltage: 1.48v
    Vcore Droop Control: Disabled
    Clockgen Voltage Control: 3.45v
    GTL+ Buffers Strength: Strong
    Host Slew Rate: Weak
    GTL REF Voltage Control: Enable
    x CPU GTL1/3 REF Volt: 116
    x CPU GTL 0/2 REF Volt: 116
    x North Bridge GTL REF Volt: 117

    DRAM Timing
    - Enhance Data transmitting: Fast
    - Enhance Addressing: Fast
    - T2 Dispatch: Disabled
    - Channel 1 CLK fine delay: AUTO
    - Channel 2 CLK fine delay: AUTO

    CAS Latency Time (tCL): 4
    RAS# to CAS# Delay (tRCD): 4
    RAS# Precharge (tRP): 4
    Precharge Delay (tRAS): 4
    All Precharge to Act: AUTO
    REF to ACT Delay (tRFC): AUTO
    Performance Level: AUTO
    Read delay phase adjust: AUTO
    MCH ODT Latency: AUTO
    Write to PRE Delay (tWR): AUTO
    Rank Write to Read (tWTR): AUTO
    ACT to ACT Delay (tRRD): AUTO
    Read to Write Delay (tRDWR): 8
    Ranks Write to Write (tWRWR): 6
    Ranks Read to Read (tRDRD): 6
    Ranks Write to Read (tWRRD): 5
    Read CAS# Precharge (tRTP): AUTO
    ALL PRE to Refresh: AUTO

    PCIE Slot Config: 1X 1X
    CPU Spread Spectrum: Disabled
    PCIE Spread Spectrum: Disabled
    SATA Spread Spectrum: Disabled
    Last edited by Booj; 09-26-2007 at 02:23 AM.

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •