-
Guys, sorry about the double post, but I was wondering if you need to do anything special to get into the ICH9R RAID menu. I am familiar with the ICH9 with the IP35 Pro and figured the RAID setup would be the same. However, I am unable to get the CTL + I menu to come up.
I have a 250G on SATA0 (or 1) - BIOS is setup for RAID and Jmicron as Native IDE. I can see my drive comes up as port 00 - correctly identifying my drive, however, I am unable to configure the drive in the RAID BIOS and/or get the CTL + I message.
Typically I'll install one drive on the RAID controller as JBOD, thus I can setup my real RAID later w/ an image.
I was able to install the OS and it properly identified the RAID driver as being used. When I navigate to the Matrix RAID in the OS, it launches properly but flags my drive as a NON-RAID disk????
Maybe this ICH9 iteration is a newer firmware and does not allow creation of JBOD, or assumes it if only 1 drive is connected w/RAID enabled?
Last edited by chawks2; 09-06-2007 at 05:56 AM.
"The only solid piece of scientific truth about which I feel totally confident is that we are profoundly ignorant about nature...It is this sudden confrontation with the depth and scope of ignorance that represents the most significant contribution of 20th century science to the human intellect."
-Lewis Thomas, The Medusa and the Snail
"The best definition we have found for civilization is that civilized man does what is best for all, the savage does what is best for himself."
-Edwin Hubble
H.E.A.T
MarioKart FID-0774-5798-8330
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Reply With Quote
Bookmarks