Quote Originally Posted by Wizzard005 View Post
Anyone here running a 6600? I cant get prime stable over 3.0Ghz for some reason.

I am running thermonelectice cooling, so temps are not a problem. If any of you can post your settings and let me know what volts your useing that would be great.

I have the following

Conroe E6600

The system wont post over 1400FSB with my DFI board., i have to reset the bios and start over. I am leaving the ram to un-linked.

I tried to set the vcore to 1.5 , 1.6 etc, nothing helps. I am running stock atm until someone fills i nthe blanks for me on why this thing wont post.

Shouldnt i be able to get 4.0Ghz+ easy with my cooler?

I had a old 6400 and I could get that to run at 3.8Ghz no the stock cooling, now i have this newer cpu and i cant get past 3.0....

Thanks you!
try something like this:

CPU VID Control................ - 1.425v
CPU VID Special Add............ - auto
CPU Drive Strength............. - Strong
DRAM Drive Strength............ - Weak
DRAM Voltage Control........... - 2.11v
NB Voltage Control............. - 1.30v
SB Voltage Control............. - 1.62v (actual 1.45v)
SB Dual Voltage................ - 1.22v
LDT Voltage Control............ - 1.22v (actual 1.16v)
CPU VTT 1.2V Voltage........... - 1.21v
GTL REF Voltage Control........ -

FSB & Frequency Seting:

FSB-Memory Clock Mode.......... - Unlinked
FSB-Memory Ratio............... - sync mode
FSB (QDR), MHz................. - 1700
=====
PCI Bus, Slot 1 MHz............ - 100
PCI Bus, Slot 2 MHz............ - 100
SPP <-> MCP Ref Clock, MHz..... - auto
LDT Frequency.................. - 5x
CPU BSelect.................... - auto
CPU Clock Ratio Unlock......... - enable
CPU Clock Ratio................ - 9x

CPU Feature:

PPM Mode....................... - Native Mode
Limit CPUID MaxVal............. - Disabled
C1E Function................... - Disabled
Execute Disable Bit............ - Enabled
Virtualization Technology...... - Enabled
Core Multi-Processing.......... - Enabled


or any variation for you likings...