I thought so too. I must say I was surprised that the full loop performed that well. That's why I did the setup carefully and with three time trials. The container I'm filling is a 2.5 gallon distilled water jug. Note that I'm running full bore on the power supply pictured. I was most pleased by the full loop numbers. I'm on generic 1/2 inch tubing on the test, and the only other thing is that I don't have the tube bends I will have in the case. The full loop test is repeatable, with consistent numbers. I've run this case before. I think the fuzion block is a wonderful thing....Originally Posted by MaxxxRacer
Note that I'm sucking the water out of the bucket in the sink, therefore it's experiencing atmospheric pressure only, not city water pressure as if I connected straight to the faucet.
That being said, if you look at Alex's opening flow numbers on page 1, my pump-only number is actually a tad lower than Alex's result.
Regards,
Bob
Reply With Quote
Bookmarks