Quote Originally Posted by firas View Post
at this moment my “DRAM Performance Control” is:

Code:
Performance Enhance.............................[ Turbo ]
Extreme Memory Profile (XMP)....................[ Auto  ]
(G) MCH Frequency Latch.........................[ 333   ]
System Memory Multiplier........................[ 2.40B ]
Memory Frequency   ..............1066...... ......1020
DRAM Timing Selectable..........................[ Manual]
first it was like this

Code:
Performance Enhance.............................[ Turbo ]
Extreme Memory Profile (XMP)....................[ Auto  ]
(G) MCH Frequency Latch.........................[ 400   ]
System Memory Multiplier........................[ 2.0D  ]
Memory Frequency   ..............1066...... ......890
DRAM Timing Selectable..........................[ Manual]
then I tried to follow what PortCitySlim said and what i was in the link I mentioned to higher my ram frequency.

2.4 multiplier wasn’t available when latch is @ 400, but it was @ latch 333 (and came with the letter B not D)

i'm thinking of giving 2.5 a shot to bring the frequency a little bit higher than 1066 since my memory voltage now is set to 2.1 (which my shallow knowledge gives me a feeling that my current frequency doesn’t require it )
At 425fsb you should be using the 266/2.50A. If port sent you my template the only reason its set to 2.00 is because this ram will not run with the 2.40B strap at 482FSB. For me 2.00D at PL9 gives me slighty better everest scores than 2.00B at PL10. Also am I seeing that correctly you have PLL set to 1.15?