mini test: some flowrates

[coolfris]

Made a single mini loop for flow testing only.

pomp > block > reservoir > flowmeter >

I used two pumps:
Liang D5 vario at setting 5 with a DetroitAC top
DCC 3.1 with XSPC top

GMR AFS1-T Flow Meter
(here is a review of this flowmeter)

mCubed T-Balancer bigNG + mCubed T-Balancer Sensorhub with mCubed T-Balancer Navigator software for read out

fittings: 4x custom iandh brass fittings & 4x BP 1/2" Push-over, 2x BP 45 rotary

and masterkleer 1/2" tubing



Koolance 30AC, Watercool Heatkiller Rev.3 , Phobya, XSPC Delta V3, EK Supreme and a round with no blocks.



edit: corrected the data here after cleaning the Supreme and rerunned the test on that block. Thanks to Hondacity for bringing that cleaning thing to my attention [/edit]

So in this results the K350 has a higher flowrate as the Supreme. In Hondacity his flowtesting recently the K350 was the block with less flow.

So is it the flowmeter I used that is responsible for this difference in result or the completely different set-ups? Hondacity his flowmeter looks a lot more pro than the thing I'v got. I know mine is not a pro thing

Another thing that I found a little bit suprising was the flow from the Heatkiller. I did't expect this block to have such a high flow. I pre-guessed it more to be in the range of the Supreme because of its simular internal design.