Test Report: XSPC RX120

[skinnee]

Good job

According to me however only three measures between 500RPM and 1800 RPM are too much little to establish the characteristics of the radiator.
Not only to know the behavior of the radiator to 500 RPM
But also for a further control of the correctness of the data.

What RPM settings do you suggest? As I said previously, I am open to adding additional test runs to the procedure. With that said, I would prefer not to have to run tests at 100RPM increments from 500RPM to 2800RPM. That would mean 24 tests per run for a total of 3 runs. 1 test run would take 36 hours of test time. The amount of time it would take to crunch the numbers and generate the write-up would grow exponentially as well.

And please note, there are 3 measurements between 1000RPM and 1800RPM, not 500-1800RPM like you specified.