JumperFree Configuration Settings
AI Overclock tuner: MANUAL
CPU Ratio Setting: 8
FSB Strap to North Bridge: AUTO
FSB Frequency: 475
PCI-E Frequency: 100
DRAM Frequency: 1:1 DDR400
DRAM CLK Skew on Channel A1: AUTO
DRAM CLK Skew on Channel A2: AUTO
DRAM CLK Skew on Channel B1: AUTO
DRAM CLK Skew on Channel B2: AUTO
DRAM Timing Control: MANUAL

1st Information :

CAS# Latency: 5
DRAM RAS# to CAS# Delay: 5
DRAM RAS# Precharge: 5
DRAM RAS# Activate to Precharge: 15
RAS# to RAS# Delay : AUTO
Row Refresh Cycle Time: 55
Write Recovery Time: AUTO
Read to Precharge Time: AUTO

2nd Information :

READ to WRITE Delay (S/D): AUTO
Write to Read Delay (S): AUTO
WRITE to READ Delay (D): AUTO
READ to READ Delay (S): AUTO
READ to READ Delay (D): AUTO
WRITE to WRITE Delay (S): AUTO
WRITE to WRITE Delay (D): AUTO

3rd Information :

WRITE to PRE Delay: AUTO
READ to PRE Delay: AUTO
PRE to PRE Delay: AUTO
ALL PRE to ACT Delay: AUTO
ALL PRE to REF Delay: AUTO
DRAM Static Read Control: Disabled
DRAM Read Training: AUTO
MEM. OC Charger: ENABLED
AI Clock Twister: AUTO
AI Transaction Booster: AUTO
Common Performance Level [5]

CPU Voltage: 1.36
CPU GTL Voltage Reference (0/2): 0.6450
CPU GTL Voltage Reference (1/3): 0.6450
CPU PLL Voltage:1.52
FSB Termination Voltage: 1.32
DRAM Voltage: 2.1
NB Voltage: 1.32
NB GTL Reference: .67
SBridge Voltage: 1.20
PCIE SATA Voltage: 1.50

Load Line Calibration: ENABLED
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew : AUTO
NB Clock Skew : AUTO



My goal is to get 4Ghz stable... Im on custom water, only the CPU and GPU are cooled by the water. What are my max voltage settings for the majors (PLL/VTT/NB etc) under water? I want to keep this chip for at least a year.

I have read A LOT of this thread but I just cant seem to get 4Ghz stable at all, most of the time, I cant even get her to boot.