my max oc:



cant not stabilize to super pi, with this config:

JumperFree Configuration Settings
AI Overclock tuner: MANUAL
CPU Ratio Setting: 9
FSB Strap to North Bridge: AUTO
FSB Frequency: 511
PCI-E Frequency: 101
DRAM Frequency: 1280
DRAM CLK Skew on Channel A1: AUTO
DRAM CLK Skew on Channel A2: AUTO
DRAM CLK Skew on Channel B1: AUTO
DRAM CLK Skew on Channel B2: AUTO
DRAM Timing Control: MANUAL

1st Information :

CAS# Latency: 5
DRAM RAS# to CAS# Delay: 5
DRAM RAS# Precharge: 5
DRAM RAS# Activate to Precharge: 15
RAS# to RAS# Delay : AUTO
Row Refresh Cycle Time: 55
Write Recovery Time: AUTO
Read to Precharge Time: AUTO

2nd Information :

READ to WRITE Delay (S/D): AUTO
Write to Read Delay (S): AUTO
WRITE to READ Delay (D): AUTO
READ to READ Delay (S): AUTO
READ to READ Delay (D): AUTO
WRITE to WRITE Delay (S): AUTO
WRITE to WRITE Delay (D): AUTO

3rd Information :

WRITE to PRE Delay: AUTO
READ to PRE Delay: AUTO
PRE to PRE Delay: AUTO
ALL PRE to ACT Delay: AUTO
ALL PRE to REF Delay: AUTO
DRAM Static Read Control: Disabled
DRAM Read Training: AUTO
MEM. OC Charger: ENABLED
AI Clock Twister: AUTO
AI Transaction Booster: AUTO
Common Performance Level [5]

CPU Voltage: 1.5325
CPU GTL Voltage Reference (0/2): 0.710
CPU GTL Voltage Reference (1/3): 0.700
CPU PLL Voltage:1.6
FSB Termination Voltage: 1.36
DRAM Voltage: 2.3
NB Voltage: 1.36
NB GTL Reference: AUTO
SBridge Voltage: AUTO
PCIE SATA Voltage: AUTO

Load Line Calibration: ENABLED
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew : AUTO
NB Clock Skew : AUTO

Advance CPU Settings
ALL DISABLED


I can not climb over the Vcore because they do not have to temperatures...