before i started priming the case, i did a quick mock up on how the components would be mounted. to make sure i would have less cuttings to do after painting.


the top rad with 3 scythes for pulling the air out


saw that i to adjust/file the 2 screw holes for the fan near the back of the case


checking the clearance, if ever i decide to go push-pull config for the top rad


the bottom rad with no fans!?


there they are... at the bottom of the case configured to push air into the case.
was actually thinking of pull config, but i think i'd be scolded and lectured on the physics of air...


another view at the bottom with 2 scythes. initially thought of putting the zalman zmf3 rls there for the bling effect,
but i decided go with function rather than form especially if the pumps are close to the rad