Quote Originally Posted by Chr0n1c View Post
Hey Praz, thanks for the reply. I should have elaborated on my question.

Can I run at 45 x 100 while still keeping the Ram @ DDR2800? I've tried setting it this way but it goes into a boot loop.

Seems the only way that works is XMP, but I encounter bios error codes for PCI/AMI/NVRAM on boot.... which is due to a device not handling the higher base clock correct?
It was testing for a little while then crashed and I got those errors. 61,67, 6b? or bd? , 9f, 96 are the bios codes I was getting.
Hello

Those are memory related errors. 2800MHz memory speed using the 125 strap will result in DMI, PCIe and so on at only slightly more than 100MHz. You may need to adjust VCCSA to get past those errors. 2800MHz on the 100 strap can be done but depending on the CPU may require quite a bit of tuning and will most likely result in higher voltages than the same memory speed with the 125 strap.