I have an issue with the motherboard tray....In this document http://www.pc-junky.com/pdfdocs/EEB_..._spec_v3_0.pdf , it says that the bottom opening of the I/O hole, is .088" or 2.25mm BELOW the base of the motherboard/standoff height.

Which is correct for this generic case, and my main Coolermaster case.

Which, the issue then becomes, the flange on the IO peice, that folds inwards towards the motherboard tray, wont fit with standard 6.5mm standoff's (being that the bottom of the opening would only be 4.2mm away from the motherboard tray, WHICH is normal in most cases (lol, double take) but because of this design, have to find a way around it.

Solutions:

Use bigger standoffs. The ones I have are 6.5mm high but i'm not sure if this is the same for everyone.


don't bother to change or add flange, just industrial glue straight to edge.
Wrap the flange 180 and turn it into an extended hem, then rivet onto actual motherboard tray.