SSD Write Endurance 25nm Vs 34nm

[Christopher]

Much too early, we'll figure it out when we start seeing some trends.

I understand, but you said you were "setting it up" for the Force 3, which is why I was confused.

It's not really something that needs to be done at 98%, unless something terrible is happening "under the bonnet".

Good news! I finally hit 98%.... I might make it through MWI before the apocalypse, assuming the apocalypse isn't three months from now.

Yes, that is a strange one, I'm seeing the same behavior.

There are other attributes that mirror the same "Raw value". (C3/C9/CC)

My Raw read error rate has plummeted down to 86, but the RAW value is also (C3/C9/CC) as you pointed out.

I think that this is something completely different than what it looks like. If this number(01) starts approaching 0, perhaps this is some precursor to throttling? I noticed it jumped back up after stopping the endurance test for a few moments so it's not likely, but it'd be nice to know what's going on. The Raw Read Error Rate sounds pretty self explanatory for mechanical HDDs, but isn't really needed for SSDs and maybe it's one of those attributes that's always included but had many uses.

This Mushkin was taken out of the box and then almost immediately started endurance testing. I'll start including 01 in updates along with power on hours, and maybe some pattern will make itself known between the two SF2281s.

EDIT
Now it's jumped back to 94.
What the hell?
I was hoping there was some correlation with another attrib. like power on hours, but sadly there is not.