Ok well I managed to get everything installed and running, loop is filled and bled and leak tested but do have a few questions/concerns about aquaero & poweradjusts...

Using aquasuite BETA 5 I updated the aqaero formware to 1013 and with aquasuite 4.72 I updated all 3 PA2 one at a time to firmware 1003, changed bus address to 50-51-52 respectively and I do see 7 fan channels in aquasuite 2012. So far so good.

But...:

1 - 2 of my aquacomputer internal/external Temp sensors indicate negative values, the 4th one (connected to PA2 #3 numbered 52 isn' t showing at all. I tried connecting it again but no luck...
2 - I've set my dual MCP35X (Fan 4) at "PWM controlled" in aquasuite 2012, but what does Calibration do? I noticed lowering the value increases the pumps' RPM on the display but doesn't seem to modify the flow rate wich is currently at 2.6 l/m. (Isn't it a bit low with dual MCP35X with 1/2id 3/4od tubing)
3 - My "Chart' pages are all empty, what can I display on these, and how?
4 - "Relay and power outputs" is also empty (0%). Do you need specific hardware to have it display something? Or something I did not installed properly?
5 - My aquaero 5 XT is recognised as "aquaero 5 pro" in System/Device in the aquasuite 2012...?

Forgive my ignorance, 1st timer here and the thing lacks english documentation really bad...

These are my questions so far. I'll probably have more in the future, but if someone could answer at least one of these for now it would be a good start.

Thank you.