Quote Originally Posted by acutech View Post
Hey thanks for the reply slavearm.

I do have an aquaero 5 XT, with capacitive touch buttons (wich also suffered from the "capacitive syndrom" until I removed the front plate, now need to find a way to put it back on without triggering the random crazy behavior...). My device is already flashed to latest v.1013.
As for the PA2's, all 3 are connected and seem to work as I do see all 7 fan channels. The problem is only with my Temp sensors, wich are aqua computers' internal/external G1/4, where 2 of wich indicate negative values ex: "<-45 ºC", OR "-43,8 ºC". The 3rd one seem fine indicating 28 or so degrees Celcius. The 4th only shows " - - " and doesn't appear in aquasuite either... I thought it wasn't connected properly but after further verification it seems installed properly.

My flow sensor is aqua computer's Flow Sensor "High Flow" G1/4. Loop runs as follow: Pumps -> Flow Sensor -> aquaero block -> RX360 Rad -> Ram Block -> CPU block -> Mobo block -> GPU block -> Reservoir -> Pumps
As you can see, the flow sensor directly follows the pumps, and when filling the loop I powered the pumps through an external power supply and the flow was visibly higher. When running from the aquaero the pumps run significantly at lower power... (I did plug the 4pin molex of both fans to the PSU).

I understand you can get aquasuite to monitor pretty much everything you want, problem is I have a hard time figuring it out right now :/

Would be nice if someone could give us a little "step by step" demonstration on how to configure a chart, or nything actually, then it would be easier figuring out the rest I guess...

Thanks,

I am haveing the same problem with my A5 XT it works fine without the faceplate but with the faceplate on it gose nuts it will run some what normal with a few random hicups as long as you dont touch it but as soon as I touch the faceplate or buttons it gose crazy i have tried optional black faceplate didnt help, tried rubber standoffs didnt help, tried mounting in my case to see if that would ground it nope didnt help,tried putting scotch tape over the back of the faceplate then along with rubber standoffs didnt help, I have tried ajusting the button sensitivity didnt help. I have spent several days trying to figure this out to no avail the only solution that i have found is to use it without the faceplate i can tell you with all the money that i have spent on this system and accessories I should not have to go through all of this crap am I wrong in thinking this thing should work out of the box? has anyone figured this problem out if not i guess I am going to try and RMA this unit and try again.