***Asus Rampage III Extreme Owners Thread***

[skuldarin]

I ll give it a try, the RTL values, but what about tRL values? I flashed to 0003 bios so i can set them, but where should i begin with them? they can be set for channel A, B and C, do i need to change them for all channels to the same value, or? go to + or - values? I just dont get it. I have 6gb of memory, yes, but i run it at 1804mhz, uncore 3608, gives me ok performance, cpu at 4.5ghz 180x25 (it would be better to use 2005mhz and 4008 uncore, but i doubt that will ever happen). I can run Prime95 small fft for hours,and games work perfectly, but blend is not working more than 2 minutes. I assumed that my cpu is stable at those voltages, and that the problem is something else (probably the memory), am I wrong? I feel like im playing bingo with this thing...it even happened to me once that i was running blend stable for like 2 hours, shut down, and in the morning, started the pc and again not stable for blend. I dont get BSODs, i get rounding errors.

you'd got RTL's and tRL's, RTL is the one i was suggesting the +2/+1 of 57-59-60 (IE, it's +2 between 57 and 59 and +1 between 59 and 60.). tRL's are the ones just below for each channel. i haven't toyed with them much to really know for sure, but keep them all with the same setting. + adds delay, - reduces delay (i think). so far i've been keeping mine between +2 and +4.

@ Cryptik - any idea as to why the 990's get such higher clockings on dramatically lower voltages over the 980's? temps too seem to be even lower even though it's technically the same chip...