***Official***Z68X/P67A-UD7 Club/Discussion/Info**

[C-N]

C_N i enabled CE1 / C2 etc and EIST but my vcore remains the same only speed and multy changes

sergio hows this working , i would like to also try power savings be nice as i stream to my tvs around the house

You have to set vcore to normal & add voltage using dvid... e.g if you need say 1.3v under load & your vid/normal is 1.2 you need to add .1 using dvid.

Be a little careful with setting these voltages UD7 looks better then 5 but I get more of a voltage overshoot under load than I do just setting vcore & level1... also vid moves about depending on core speed so not always 1.2v & its this I am moaning about on UD5....

Edit....

Thanks Sin that mos leg was right & measures .03 more than set in bios so well worth checking.