Nope you don't need to unless you want to increase TDP and TDC, but i think the UD7 has no problem with this, like the UD4 does. It seems most people have to enable TDp and TDc and raise it to 200-300 to get higher OCes with the UD4.Originally Posted by jackbrennan2008
also for your OC 1.6v with LLC1 or even 2 should be tried for the heck of it, i have seen 5.7 on this board.
hey so i just tried and I can change BLCk in windows with ET6. I have everything loaded to optimized defaults with blck control disabled, and I am able to change blck through windows. I am trying different combos like cpu pll overvoltage enabled and ratio os change and turbo and votlage and everything.
I have teh same action, blck control will be disabled on boot up, then when i change blck through ET6 it enabled it upon reboot.
i also found another wierd thing, when i set 107.7blck you can watch CPU-Z slowly change blck in increments and then it froze at 105.9, 107.7 blck was stable on my other chip with BIOS F6E, this BIOS is a no go for my better chip and BLCK, max is lower than 107. i believe that BLCK is tied into chip as well as board.
TEvery time you change blck in BIOS the system hard resets itself, i thought that the blck since was fed through the PCH the PCH had to be reset to change blck, i guess this is not true, you can indeed change blck through windows. CPU-Z version 1.56.2(i know 1.56.3 is out) BIOS F7E, and ETS B10.102.1. i am going to try the latest version of easytune.
Latest easytune off GB website works as well.
Reply With Quote
Bookmarks