Just a little word of warning... Tolerance in the mosfet area is very tight indeed.
I've just fried my R3Gene with the block... First it was shorting the components to the right of the block (on the CPU socket side) which made the PSU automatically switch off after a fraction of a second of powering on (good for Corsair's short circuit protection!). The motherboard did survive this.
However, when I repositioned the block it made contact with that grey cube marked with a "C" just below the EATX power socket, and that did kill the poor thing.
Not trying to blame anyone but myself, Eddy is not responsible for different manufacturing tolerances or less than ideal mounts, just a word of advice.
Second motherboard I insulated the perimeter using kapton tape and now is all good and dandynot the most sightly approach if you're after bling though
![]()
Bookmarks