***Official*** eVGA Classified SR-2 Thread

[punx223]

I checked both sockets for bend pins and tried booting with just one CPU, 0 and 1

tried the other bios chips im guessing?

sounding like you definitely may need an RMA

[Mydog]

tried the other bios chips im guessing?

sounding like you definitely may need an RMA

Yepp tried all of them but thanks any way.

RMA approved by Florian yesterday.

[Sam_oslo]

Something funny. E-LEET and CPUID HW Monitor (and other monitoring SW too, I guess) are actually showing the CPU#0-temp as CPU#1-temp.

I've been crunching in past 2 days for November-challenge, but then I didn't like the idea that CPU#0 was 5-6'C hotter. So I decided to put a better fan on CPU#0, but in my amusement, the temp on CPU#1 went down.

I have always had better fans on CPU#0, becouse monitoring SWs were fooling, but I've just moved my best fan (Scythe Slip Stream 1600RPM) from CPU#0 to pull from CPU#1 (all 3 other fans are quiet 1200RPM). The core-temp-difference has almost equalized between 2 CPUs after that As seen in the picture blow. BTW may baby has been running really smooth with this settings at 100%-load in almost 48 hours before i stopped it to change fan.

[punx223]

Something funny. E-LEET and CPUID HW Monitor (and other monitoring SW too, I guess) are actually showing the CPU#0-temp as CPU#1-temp.

I've been crunching in past 2 days for November-challenge, but then I didn't like the idea that CPU#0 was 5-6'C hotter. So I decided to put a better fan on CPU#0, but in my amusement, the temp on CPU#1 went down.

I have always had better fans on CPU#0, becouse monitoring SWs were fooling, but I've just moved my best fan (Scythe Slip Stream 1600RPM) from CPU#0 to pull from CPU#1 (all 3 other fans are quiet 1200RPM). The core-temp-difference has almost equalized between 2 CPUs after that As seen in the picture blow. BTW may baby has been running really smooth with this settings at 100%-load in almost 48 hours before i stopped it to change fan.

let me check out that sensor issue for you... I will see if I can reproduce in teh lab, and if so, I will work to get it corrected.

Thanks for the feedback sam