No easy fill/bleeding the second inlet is too low. Afterward I'd have to go into the case and remove the cap of the res to bleed the air, I'm pretty sure if I had extra fluid in the fill line and took off the cap the pressure would make it pour out the top if there was enough fluid. Defeating the whole purpose of a case mounted fill line for easy top ups.
And I want a pressure value on my res's I know its not proven but I still believe expansion pressure is the cause of most acrylic cracks.
Besides if I put a line to the second inlet where am I gonna put my Super bright white led for lighting up my res ?
Reply With Quote
Bookmarks