Discovered new BIOS today.
No idea what 'broken' PLL Voltage is, left it at default/1.8v

After 1 year, I finally spent a bit of time trying to get my CPU somewhere.
Currently sitting @ 196*20

I'm stuck @ 196 Bclck with 1.45vtt, 197+ will return 8.8. on the diagnostic LED. Have to clear CMOS to get it to post again. Is there some kind of hole?

Genie BIOS Setting

CPU Feature
Set VR Current Limit Max: Enabled
Thermal Management Control: Disabled
EIST Function: Disabled
CxE Function: Disabled
Execute Disable Bit: Disabled
Virtualization Technology: Disabled


***** Logical Processor Setting *****
Intel HT Technology: Enabled
Active Processor Cores: All

DRAM Timing
All auto except 9-9-9-25 @ 2T

Voltage Setting
O.C. Shut Down Free: Disable O.C.S.D.F
CPU VID Control: 1.356
CPU VID Special Add Limit: Enabled
CPU VID Special Add: Auto
Vcore Droop Control: Enabled
DRAM Bus Voltage: 1.620v
DRAM PWM Switch Frequency: nominal
DRAM PWM Phase Control: 2 Phase Operation
CPU VTT Special Add: AUTO
CPU VTT Voltage: 1.45v
VTT PWM Switch Frequency: nominal
VTT PWM Phase Control: 2 Phase Operation
CPU PLL Voltage: 1.80v
IOH/ICH 1.1V Voltage: 1.13v
IOH Analog Voltage: Default
ICH 1.5 Voltage: 1.7v
ICH 1.05V Voltage: 1.15v
DIMM 1/2 DQ/DQSTB Bus VREF: -00.0%
DIMM 3/4 DQ/DQSTB Bus VREF: -00.0%
DIMM 5/6 DQ/DQSTB Bus VREF: -00.0%
ADDR/CMD VREF Control: Disabled
x DIMM 1/2 ADDR/CMD Bus VREF: 110
x DIMM 3/4 ADDR/CMD Bus VREF: 110
x DIMM 5/6 ADDR/CMD Bus VREF: 110
CPU QPI Drive Strength: Normal
IOH QPI Drive Strength: Normal

PPM Function: Enabled
Turbo Mode Function: Disabled
1 core Max Turbo Ratio: 22x
CPU Non-Turbo Clock Ratio: 20x

* BCLK/UCLK/QPI Controller Settings *
QPI Control Settings: Enabled
QPI Link Fast Mode: Enabled
QPI Frequency: 4.8GT(lowest)
CPU Base Clock (BCLK): 196 Mhz
Boot Up CPU Base Clock: 155
PCIE Clock: 100 Mhz
DRAM Frequency: x10
UnCore Frequency: x20

CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled