Heatkiller 3.0 - installation issue ?

[SwIeRsZcZ]

I wonder if everything is ok...

I have single loop , HK 3.0 block , MCP355 and Feser TripleRad + 3xNoctua 1200RPM .

Here's how it looks like, is my inlet/outlet connection ok ???





Another thing... Have heared that tension with Heatkiller should be 19.8mm however I did found some posts where people say 18.8 :/ So finally.. whats the answer ?? BTW... I use HK backplate...


Now my OC is 4.35GHz @ 1.38v HT on, EIST C1E etc. turned off...

My idle temps stay between 41-45C . During stress (LinX) max temp. is 82C .

Wonder if these temps are ok... I see many people whos idle temps stay around 30C on water.. :/