Quote Originally Posted by mountaindew View Post
Some decent talent working with acrylic. Some methods are a little dangerous but we all do fabrication at times with less then the best part setup.
And great vision for your design!
Very interesting thread to follow, keep up the quality work.
md
Cheers, mountaindew. Your right about certain methods being a little dangerous but it's the only way i could come up with using the tools i have . i'd love a proper mill, that would keep the old digits safe


Quote Originally Posted by Wezly View Post
Wowza!

No really, I want a lathe more than ever now. A mill even more!

This is amazazazing.

You should seriously consider manufacturing retail parts.

What happened to the old ssd holders? I liked them :<
Thanks man .

I would highly recommend a mill and a lathe, but don't go cheap! I went cheap on the lathe (even though it still cost me a grand ) and i constantly feel like throwing it out the window! I get bad vibrations, the tailstock is a b!tch to move, and the cross-slide's not rigid at all unless i tighten the screws to the point i can't even turn the handle! But it get's the job done so i can't complain too much .

Oh and the SSD holders are collecting dust in the cupboard . The seems where they were glued can be seen under certain light so i decided not to use them (but that was a while ago now).