***Asus Rampage III Extreme Owners Thread***

[Leeghoofd]

Hello everybody, am new to the forum and this is my 1st post


sync mode: ENABLE

Ai overclock Tuner: MANUAL
OC from CPU level up: AUTO

CPU Ratio setting: 21
CPU Turbo power limit: ENABLE

Cpu configiguration:

BCLK Freq: 190
PCIE Freq: 103
Dram Freq: DDR3-1523MHZ
UCLK Freq: 3046
QPI Link Data Rate: AUTO

Memory Configuration protect: DISABLE
Dram timing Control --> set timings to manual eg 8-8-8-24 andTRFC to 88

Cpu Differential Amplitude: AUTO
CPU clock skew: AUTO
IOH Clock skew: AUTO


Digi+ pwr mode: X-POWER
pwm volt control: AUTO
Load-line calibraction: AUTO
CPU voltage OCP: ENABLE
CPU PWM Freq: AUTO

Extreme OV: DISABLE
Extreme OC: AUTO

CPU voltage: 1.32
CPU pll voltage: 1.81525
QPI/Dram core voltage(vtt): 1.35 (try to lower later)
Dram Bus voltage: 1.65
IOH voltage: 1.20575
IOH pcie voltage: AUTO
ICH voltage: 1.20575
ICH pcie voltage: AUTO

CPU spread spectrum: DISABLE
PCIE spread spectrum DISABLE

________________________________

CPU Ratio Setting: 21
C1E Support: DISABLE
Hardware Prefetcher: DISABLE
Adjacent Cache Line Prefetch: DISABLE
Intel Virtualization Tech: DISABLE
CPU TM Function: DISABLE
Intel HT Technology: ENABLE
Active Processor Cores: ALL
A20M: DISABLE
Intel SpeedStep(TM) Tech: DISABLE
Intel C-STATE Tech: DISABLE

Try the above plz... I can boot and be stable at 227 Bclock with my crap 950... no other board has done that here (not Xpower, not UD9)

[calves]

Try the above plz... I can boot and be stable at 227 Bclock with my crap 950... no other board has done that here (not Xpower, not UD9)

ok, I'll do that and add 200 in bclk to 4.2, very soon send news, and thanks for the quick replies

By the way sorry ignorance but what is the option (UD9) ?

[kortas]

ok, I'll do that and add 200 in bclk to 4.2, very soon send news, and thanks for the quick replies

By the way sorry ignorance but what is the option (UD9) ?

He's refering to the Gigabyte UD9 Motherboard.

Ill post you my template tonight, if your still having no luck, I'm at work atm.

[calves]

Try the above plz... I can boot and be stable at 227 Bclock with my crap 950... no other board has done that here (not Xpower, not UD9)

Leeghoofd I have no luck, I did exactly everything you said and did not work after 12 seconds in LinX i have a blue screen, then try again with the Vcore to 1.38 and still gave error on LinX after 13 seconds.