Project: Lian-Li P80 & PA140.3

[aka_GK]

I've been looking at this case, to use with EVGA SR-2. It seams to fit, but I'm not sure. You guys seams to know this case inn and out, do you think a MB with Length: 13.6in - 345.4mm and Width: 15in - 381mm, would fit in this case?

MB tray has about 430mm of height and 330mm of width + 50mm of distance between tray and drive bays

=============================================
okay, time to finish PSU (finally LOL)
At the beginning I heatshrinked sleeving just near the PSU output but it turned out not good, at all. I remade it and now it's much better, let's watch step by step:

Slightly widened the hole, it was completely round at first. Bare metal edge can be fixed with Sharpie


Then put all sleeving inside and fixed with zip ties. Also snipped SATA cables and 4-pin motherboard power cable.


And now there is only 4-pin molex left naked, will do it later while prefinal assembly to cut it to exact length.