Here´s a bios template for the Rampage III Extreme
Courtesy of donmarkoni for the template
Code:Target CPU Frequency XXXXMHz Target DRAM Frequency XXXXMHz LN2 Mode []*** QPI Loadline Calibration []*** Sync Mode [] AI Overclock Tuner [] OC From CPU level Up [] CPU Ratio Setting [] CPU Turbo Power Limit [] >CPU Configuration---------------------------- CPU Ratio Setting [] C1E Support [] Hardware Prefetcher [] Adjacent Cache Line Prefetcher [] Intel(R) Virtualiyation Tech [] CPU TM Function [] Execute Disable Bit [] Intel(R) HT Technology [] Active Processor Cores [] A20M [] Intel(R) SpeedStep(TM) Tech [] Intel(R) C-STATE Tech [] C State package limit setting [] ---------------------------------------------- BCLK Frequency [] PCIE Frequency [] DRAM Frequency [] UCLK Frequency [] QPI Link Data Rate [] Memory Configuration Protect [] >DRAM Timing Control-------------------------- CAS# Latency [] RAS# to CAS# Delay [] RAS# PRE Time [] RAS# ACT Time [] RAS# to RAS# Delay [] REF Cycle Time [] WRITE Recovery Time [] READ to PRE Time [] FOUR ACT WIN Time [] Back-To-BackCAS# Delay [] Timing Mode [] Round Trip Latency on CHA [] Round Trip Latency on CHB [] Round Trip Latency on CHC [] WRITE To READ Delay(DD) [] WRITE To READ Delay(DR) [] WRITE To READ Delay(SR) [] READ To WRITE Delay(DD) [] READ To WRITE Delay(DR) [] READ To WRITE Delay(SR) [] READ To READ Delay(DD) [] READ To READ Delay(DR) [] READ To READ Delay(SR) [] WRITE To WRITE Delay(DD) [] WRITE To WRITE Delay(DR) [] WRITE To WRITE Delay(SR) [] ---------------------------------------------- CPU Differential Amplitude [] CPU Clock Skew [] IOH Clock Skew [] ------------ Extreme Engine Digi+ ------------ Digi+ PWR Mode [] PWR Volt. Control [] Load-Line Calibration [] CPU Voltege OCP [] CPU PWM Frequency [] Extreme OV [] Extreme OC [] CPU Voltage [] CPU PLL Voltage [] QPI/DRAM Core Voltage [] DRAM Bus Voltage [] >DRAM REF Voltages---------------------------- DRAM DATA REF Voltage on CHA [] DRAM CTRL REF Voltage on CHA [] DRAM DATA REF Voltage on CHB [] DRAM CTRL REF Voltage on CHB [] DRAM DATA REF Voltage on CHC [] DRAM CTRL REF Voltage on CHC [] ---------------------------------------------- IOH Voltage [] IOH PCIE Voltage [] ICH Voltage [] ICH PCIE Voltage [] ---------- Spread Spectrum Control ----------- CPU Spread Spectrum [] DRAM Spread Spectrum [] ***on-board jumper dependant
Yet another bios template from donmarkoni, this one is for bios 0009, included a setup with Bclk @ 200, Cpu @ 4200, Dram @ 1600 676 18 1N, Uncore @ 4000 and QPI @ 7200.
Many thanks to donmarkoni
Code:Target CPU Frequency 4200MHz Target DRAM Frequency 1603MHz LN2 Mode: Disabled*** QPI Loadline Calibration: Enabled*** Sync Mode [Enabled] AI Overclock Tuner [Manual] OC From CPU level Up [Auto] 2D Performance Booster [Disabled] CPU Ratio Setting [21.0] CPU Turbo Power Limit [Disabled] >CPU Configuration---------------------------- CPU Ratio Setting [21.0] C1E Support [Enabled] Hardware Prefetcher [Enabled] Adjacent Cache Line Prefetcher [Enabled] MPS and ACPI MADT ordering [Modern] Intel(R) Virtualization Tech [Enabled] CPU TM Function [Disabled] Execute Disable Bit [Enabled] Intel(R) HT Technology [Enabled] Active Processor Cores [All] A20M [Disabled] Intel(R) SpeedStep(TM) Tech [Enabled] Performance/Watt select [Power] Intel(R) C-STATE Tech [Enabled] C State package limit setting [Auto] C1 Auto Demotion [Enabled] C3 Auto Demotion [Enabled] ---------------------------------------------- BCLK Frequency [200] PCIE Frequency [100] DRAM Frequency [1603] UCLK Frequency [4009] QPI Link Data Rate [7218] Memory Configuration Protect [Disabled] >DRAM Timing Control-------------------------- CAS# Latency 6 [6] RAS# to CAS# Delay 7 [7] RAS# PRE Time 6 [6] RAS# ACT Time 18 [18] RAS# to RAS# Delay 4 [4] REF Cycle Time 72 [72] WRITE Recovery Time 10 [10] READ to PRE Time 6 [6] FOUR ACT WIN Time 24 [Auto] Back-To-BackCAS# Delay 0 [Auto] Timing Mode 1N [1N] Round Trip Latency on CHA 59 [59] Round Trip Latency on CHB 61 [60] Round Trip Latency on CHC 62 [61] WRITE To READ Delay(DD) 8 [Auto] WRITE To READ Delay(DR) 8 [Auto] WRITE To READ Delay(SR) 18 [Auto] READ To WRITE Delay(DD) 7 [Auto] READ To WRITE Delay(DR) 7 [Auto] READ To WRITE Delay(SR) 7 [Auto] READ To READ Delay(DD) 7 [Auto] READ To READ Delay(DR) 6 [Auto] READ To READ Delay(SR) 4 [Auto] WRITE To WRITE Delay(DD) 7 [Auto] WRITE To WRITE Delay(DR) 7 [Auto] WRITE To WRITE Delay(SR) 4 [Auto] ---------------------------------------------- CPU Differential Amplitude [Auto] CPU Clock Skew [Auto] IOH Clock Skew [Auto] ------------ Extreme Engine Digi+ ------------ Digi+ PWR Mode [T-Balanced] PWR Volt. Control [Auto] Load-Line Calibration [Full] CPU Voltege OCP [Enabled] CPU PWM Frequency [Auto] Extreme OV [Ensabled]* Extreme OC [Auto] CPU Voltage 1.343 [1.33750] CPU PLL Voltage 1.349 [1.35150] QPI/DRAM Core Voltage 1.429 [1.43750] DRAM Bus Voltage 1.654 [Auto] >DRAM REF Voltages---------------------------- DRAM DATA REF Voltage on CHA [Auto] DRAM CTRL REF Voltage on CHA [Auto] DRAM DATA REF Voltage on CHB [Auto] DRAM CTRL REF Voltage on CHB [Auto] DRAM DATA REF Voltage on CHC [Auto] DRAM CTRL REF Voltage on CHC [Auto] ---------------------------------------------- IOH Voltage 1.111 [Auto] IOH PCIE Voltage 1.508 [Auto] ICH Voltage 1.111 [Auto] ICH PCIE Voltage [Auto] *QPI Voltage OCP [Enabled] *IOH Voltage OCP [Enabled] *DRAM Voltage OCP [Enabled] *QPI PWM Frequency [Auto] *IOH PWM Frequency [Auto] *DRAM PWM Frequency [Auto] ---------- Spread Spectrum Control ----------- CPU Spread Spectrum [Disabled] DRAM Spread Spectrum [Disabled] ***on-board jumper dependant
Reply With Quote
Bookmarks