Official DFI LanParty UT X38-T2R(and LT) Discussion/Review/Overclock/Guide Thread

[Tuthmose]

Thanks for the feedback, Zsamz.

I’m confused, though (yeah, I know, that’s obvious). Do you mean I should change the GTL’s in my working 400MHz setting above, or I should use the GTL’s you listed to get stability at 450?

If you mean the ones I posted for my working 400MHz config are too low, could you clarify? Aren’t the GTL values for a Quad supposed to be set just a tad higher than the 67% referenced from this chart? According to that, the 67% values that correspond to my current 1.42 VTT and 1.479 NB would be 97/96 and 102 respectively. What did I misunderstand?

Thanks,
-Tuthmose

EDIT: Still have no idea how to get to 450MHz, but I did get it running stable at 400*9 with lower VTT and NB (1.36v each) along with commensurately lower GTLs, dropping my temps. The failures to boot at anything above 400Mhz FSB throw a C1 error, so that's something I've not set right with memory, right?