Project: Lian-Li P80 & PA140.3

[aka_GK]

perhaps this link will help give you some ideas.
Baby SATA
it about cutting a SATA cable smaller, perhaps using a longer SATA cable and cutting it down will suit your needs.
I myself never tried it.

thx for the link, it helped me to decide to not cut the SATA

is getting more and more beautiful!

thanks

I ordered the same fans

very nice work dude.

thanks, glad to see ya here

Looking great as always. I like the hard disk mounting you've done.

I could never work out what the hell that piece of metal was for that comes with the P80 - you've found a good use for it :P

Thank you mate.
Yeah it turned out well, on par with TMS-200 bracket it is waiting for the final layer of black paint.

As for the Dot's.
When you go to re-paint the temp sensor with the top coat (colour you want to see).
The paint will act the same way and be pushed to the sides, leaving a hole without paint over it.
You can paint it like 5 times and the same thing will keep happening.
The only thing that will change is, around the outside of the "Dot" will form a thick ridge of paint, that should of been over the hole, it will end up looking butt ugly.

Sure, I am not going to cover them with paint. They will be black too, that's all I need

Finally it turned out great


I did some overclocking yesterday and hit 4.5GHz - completely LinX stable without crazy voltages and temps that was my goal when I started this build, but now I see that I can go even higher

This was made at 27C ambient with rad fans running 1000rpm and it looks like voltages can be lowered a bit