GTX285 various mods.. which may work for GTX260/280/295 also

[NapalmV5]

I have a couple of questions:

- on first picture (page 1 of this thread) of Napalm mods there is a 10 ohm resistor connected to ground labeled OCP mod, from same point of Crotale mod but he suggest a 15 kohm resistor. Why this difference?
I put a 15 kohm between Crotale point and ground but sometimes I have OCP triggering in, even at 1.29 V. Which resistor value do you suggest?


- I connected also the 150 ohm resistor of Napalm mod #3 to ground (mod #1 and #2 already done) but I have only 1.29 V. Can I lower or increase this resistor to get more volts, i.e. around 1.35?



Thanks in advance and bye.

you got to do step 2

heres the fix.. which im also gonna replace step 2 with

this little bastard is the reason why some of you are @ 1.2vgpu after bridging (resistor @ over 10k)
this little bastard is the reason why some of you are @ 1.3vgpu after bridging (resistor @ under 10k)
this little bastard is the reason why solid color screens still kick in after ocp mod

step #2
- this step is a must after step 1^ if only 1.2vgpu is achieved
- lower resistance (ex: by pencil) to 9K ohm at first then lower from there
- mod increments vgpu ~1.3-1.38

Is the connection 3 on SMD component a ground? If yes, I suppose I could connect a simple resistor of 15 K between point 2 and any ground nearby.

Do you agree?

ocp mod

i want to make sure you guys do the ocp mod properly if/when not following crotales guide

yellow encircled red point to ground


note: use fixed 10 or 100 or 1000 ohm resistor whatever you guys are comfortable with

i gained @ 10k ohm resistor/i gained @ 1k ohm resistor/use whatever fixed resistor you got between 10 ohm and 1000 ohm

sure you can try a 100 ohm resistor @ step 3