Quote Originally Posted by WeeMaan View Post
I'm using staples.
Did'nt notice any problems when I first sleeved all cables individually (it's all done) but when I had to remove them again to put some big heatshrink for the transition of the beginning (with big sleeve) and the individually sleeved cables
they just started to break one after one.
Even tryed without any heatshrink and it was the same.

Edit: Dragon - The problem is the first pic won't stick to the second pic when I insert them.


the molex block you show in that pic is a male block (requiring male pins) but the pins you show in the picture are female pins, I suspect this is your issue.