Cable Sleeving Guide

[WeeMaan]

WeeMaan. What tool are you using to remove the pins? It sounds like you're damaging the plastic housing or the pins themselves.

One reason the pins may not stick is because of the amount of heatshrink you might try putting in the housing. That's just something I've noticed a problem, may or may not be yours at all.

What psu are you sleeving?

I'm using staples.
Did'nt notice any problems when I first sleeved all cables individually (it's all done) but when I had to remove them again to put some big heatshrink for the transition of the beginning (with big sleeve) and the individually sleeved cables
they just started to break one after one.
Even tryed without any heatshrink and it was the same.

Edit: Dragon - The problem is the first pic won't stick to the second pic when I insert them.