Hey guys, I've been running the UD5 for over a month now, and I love it. The past week I've been getting Thermalright stuff for the board. I have a HR-05 IFX non-sli for the IOH, a HR-05 SLi for the Southbridge, and the HR-09 U and S Trype3 for the mosfets.

Ok, I already installed both HR-05 heatsinks, then when I was about to install the HR-09U Type3 on the mosfets close to the I/O port, the damn thing can't fit! But for the HR-09 S Type3 for the upper mosfets is fine. So I checked the Thermalright site just to double check if I bought the right coolers for the mosfets, and yes, it's stated on the Motherboard Compatibility List: http://www.thermalright.com/new_a_pa.../05-09-mcl.htm

I measured the heatsinks for the mosfets of the stock heatpipe assembly and found out the measurements were the same as the HR-09 type4. That really sucks! I'm pissed off about it. Especially that it states on the list that it's compatible...but no it's not. :SIGH:...