Well, I finally got 4.2GHz Prime95 Blend Test stable!!

I have to set Vcore to 1.34v in the BIOS, but QPI is only 1.335v, CPU PLL is 1.300v, IOH Core 1.160v, QPI PLL 1.160v, VDimm on 1.66v and all other voltages are on auto.

Been running Prime95 for just over 6 hours now, and it is still going, so I would say it is stable, however, I am going to leave it running overnight just to be sure.



Temps are a little high for my liking, but I'm putting my chip under water in the next couple of weeks, I have got my 120.3 rad, fittings and fans being delivered tomorrow, so the only thing I need to get after that is my Heatkiller 3 copper, and I will be all set to start planning my loop layout, I don't know whether I should use both my 120.2 and 120.3 rad in the loop or not, I will need to have a think about it, and see where everything is going to go, as it might be tricky for me to fit both rads inside my current case, however, I will be getting the Silverstone TJ07 in November to replace my TJ10, so I know that I will have plenty of room in the TJ07 for both rads, and I won't need to hack it up in order to make things fit..