Quote Originally Posted by BLunTSmoKeR View Post
@hlonpiha, what do you have all of your voltages set to for 4.43GHz in your sig?

I'm putting my chip under water in a couple of week's and I would like to get my chip at 4.4GHz stable.

I'm fairly confident that it will do it, as I have verified my chip with CPUZ at 4.7GHz, but I would like to see what kinda voltages other people are using for these kind of clocks.

::edit::

My highest O/C yet with my current 920!





I got it up to 222 Bclk in the BIOS, and then used SetFSB to knock it up a little further for this o/c.
the voltages on my classy board are way different than the ones I used on the UD5 (I ran an UD5 for awhile before my classy board) once home later I will post them for you but I'm positive that my settings will not bring any help to you with the UD5.
Not to discurage you but in my experience a max clocks validation in not way relates to what we call stable clocks(8hrs prime run). your required volts for 4.2 are fairly high comparing to what mines are. (1.25v) but to keep mine fully stable as you can see I had to bring my volts to 1.42v@4.43ghz ht on.
The generated heat is massive at those clocks full load after the 4-5 hrs. and I have a very good WC setup.

good luck in your clocking!!!!!!

hlo