Quote Originally Posted by misho View Post
OK so: I tried everything from scratch at 8x multiplier, and voltage that is 0.025+ above stock, because If i leave it at auto, i dunno what voltage is gunna end up. Screenie::
So, with these minimal voltage increase I got up to FSB of 463mhz. At this FSB, i pass orthos CPU stress and the gromacs core. When I do the blend and ram test, fails after couple of seconds.

What should I do from here?
look at your Nb voltage it reads out 1.12, that's freaking low... giver her more volts there... if it passes the cpu test yet fails on blend it's usually bad setup of the NB voltage and GTL's...

maybe your cpu will only run at 4.5 with 1.45Vcore, not all EO cpu's are golden eggs and with FSB voltage around 1.3