Quote Originally Posted by Leeghoofd View Post
K some facts : you really think you can get away with a mere 0.03Vcore increase to go from 4.2 to 4.5 ?

Why don't you try to stabilise 500FSB first with eg 8 multi. Those voltages you are pumping through the NB and CPU seem way out of control... Did you verify the voltage outputs via a DMM. Or are these the bios voltages you put in ?
Which Orthos test does it fail ? Blend, Small or large ?

First determine the Vcore via Small FFT , then work on the rams later...

You are going too fast and are wasting maybe a perfectly okayish CPU by just pumping volts. More isn't always better. Each board/CPU needs a certain combination of values to work, just upping one setting is not always enough...

Also did you copy a template of someone ? Sometimes that doesn't work at all... ; GTL tweaking and co is very CPU, Mobo, RAM dependant... try 3 the same boards and they all might need diferent settings

I never really worked with the biostar as my board smoked from day 2 at light load... I immediately sold the RMA...

I would start from zero , use 8 multi and slowly work ya way up on the FSB... else you will end up to be a very frustrated user... it could be ya CPU is a pos, but the voltages I see here are totally out of bounce...
OK so: I tried everything from scratch at 8x multiplier, and voltage that is 0.025+ above stock, because If i leave it at auto, i dunno what voltage is gunna end up. Screenie::
So, with these minimal voltage increase I got up to FSB of 463mhz. At this FSB, i pass orthos CPU stress and the gromacs core. When I do the blend and ram test, fails after couple of seconds.

What should I do from here?