[ Project ] : Altair | A Lian-Li PC-P80, dual loop, all internal build

[Laine]

I hope you're steadier on the hand with the saw then I was.

Last time I used one I couldn't figure out if what I've done was a cut or a maze.

Also, new pics would be appreciated.

[eponymous]

hum hum hum... nice work your doin' there so how are you gonna mount those rez's? In the bays with this plexi plate?

I'm planning to bolt the plastic on to the end of the motherboard tray (towards to end where the drive bays are) and mount the res's there, side by side. I'll use the DDC brackets underneath to hold the pumps in place.

I hope you're steadier on the hand with the saw then I was.

Last time I used one I couldn't figure out if what I've done was a cut or a maze.

Also, new pics would be appreciated.

I thought about using a circular saw but decided it wasn't worth it for the amount I'd actually use it.

I'll be posting some new pics up this weekend when I fit the CPU block (hopefully) :P.