DFI UT X58-T3EH8 continued - Part 2

[Peen]

I'm in 0724 BIOS now, so far so good and no problems...

Weird, my PC was just shutting off randomly, now its not again with 6/19

In order to get x21 multiplier, do you have EIST enabled?
Because Im on win7 professional and I need to have it on to reach x21.

And... I have 7/24 bios.

Also, I would like to know which are the safe voltages for VTT and PLL.
And is it true that you only need to add more vtt when you have 2000mhz memory modules?

Thanks

Ya you have to have EIST on

I run 1.45v vtt because my uncore is 4.2ghz. If it dies, it dies. Somehow I doubt it will though. People were afraid to go over what was it 1.35v with Penryn and I ran 1.55 for a year with no problems

They say higher VTT helps stablize ram at higher speeds, couldn't tell ya though since my board hates my ram and have to run it at 1260mhz. Pretty sure intel says 1.35v max but so far so good with 1.45v

pll couldn't tell ya, I run stock because it doesn't seem to make a difference with anything. I think Intel says 1.89v max