Gigabyte EX58-UD5/Extreme Discussion Thread

[Infa]

Hey there
thank you soo much for the help
have tried setting the uncore to 24+1 along with ram volts all the way up to 1.66v / QPI at 1.40and that didnt get me stable either..
i have a few doubts about the sub timings for the ram..
i set 8-8-8-21 @ 2T manually for each channel.. and XMP is OFF. XMP on makes no difference to stability for me...
Have you left all the other advanced DRAM settings on auto ?


would love it if someone with the Dominator CL8 kit to post their ram sub timings or tell me if they left the following settings on auto and still got stable @ 1600mhz under OCCT .

Basically do i have to adjust any of the following values to get stable @ 1600 mhz for the Corsair Dominator TR3X6G1600C8D Kit ?
I have a feeling its these Sub timings that are preventing me from running the ram stable @ 1600 mhz.


##Channel A Advanced Timing Control##
tRC .................................?
tRRD ..................................?
tWTR .....................................?
tWR ........................................?
tWTP .......................................?
tWL ........................................ ?
tRFC .......................................?
tRTP .......................................?
tFAW .....................................?
Command Rate (CMD) ................2

##Channel A /B /C Misc Timing Control##
Round Trip Latency ...................?

##Channel A /B /C Turn-Around Settings##
...........................................??



Thanks again for all the help guys
i want to run my ram at full speed and i cant seem to do that

I actually have the 3GB kit.. will return to you in a while with my settings, shouldnt matter so much 3 or 6gb, not anymore tough.

EDIT: took a screen of my timings,turnaround i have to go to bios..cannot do that right now..
have Extreme, on the mem turbo.