Quote Originally Posted by Bl0ss0m View Post
@Bluntsmoker and Toolius, this should help http://forum.corsair.com/v3/showthread.php?t=75932 also as mentioned before, have the Uncore set to 2 times the DRAM multiplier or 2 times + 1. ie 12x DRAM multi, Uncore should be set at 24 or 24+1

Personally I have my DRAM voltage set at 1.68 which EasyTune6 will say DRAM is at 1.648 and QPI/VTT set at 1.32.

I do wish to know where are the read points on the mobo for a multimeter.
Hey there
thank you soo much for the help
have tried setting the uncore to 24+1 along with ram volts all the way up to 1.66v / QPI at 1.40and that didnt get me stable either..
i have a few doubts about the sub timings for the ram..
i set 8-8-8-21 @ 2T manually for each channel.. and XMP is OFF. XMP on makes no difference to stability for me...
Have you left all the other advanced DRAM settings on auto ?


would love it if someone with the Dominator CL8 kit to post their ram sub timings or tell me if they left the following settings on auto and still got stable @ 1600mhz under OCCT .

Basically do i have to adjust any of the following values to get stable @ 1600 mhz for the Corsair Dominator TR3X6G1600C8D Kit ?
I have a feeling its these Sub timings that are preventing me from running the ram stable @ 1600 mhz.


##Channel A Advanced Timing Control##
tRC .................................?
tRRD ..................................?
tWTR .....................................?
tWR ........................................?
tWTP .......................................?
tWL ........................................ ?
tRFC .......................................?
tRTP .......................................?
tFAW .....................................?
Command Rate (CMD) ................2

##Channel A /B /C Misc Timing Control##
Round Trip Latency ...................?

##Channel A /B /C Turn-Around Settings##
...........................................??



Thanks again for all the help guys
i want to run my ram at full speed and i cant seem to do that