CeBIT: Corsair raids the chassis market: competitors beware?

[Brandito]

liking the changes, VERY nice!!

i see it says 4 fans are included, however i count just 3. the intake on the bottom, the rear exhaust, and the intake for the hot swap bays. where is number 4? at first i assumed one was included at the top, but it then goes on to say that there's room for 3 MORE 120mm fans suggesting there's another fan somewhere else?

edit: i'm guessing the hotswap bays use a push pull fan setup? there must be another 140mm fan on the other side. either than or possibly one at the very bottom of the case where the other two 3.5" bays are?

edit edit: hmm, something else i didn't see, you guys added the ability to mount a 120mm fan on the lower 3.5" bays in the same orientation as the hotswap bays fan, this suggests that my second guess for the hidden 140mm fan is wrong. either way that's a nice little bonus feature you added their

another question though, does the cover for the hotswap bays pc board allow you to still plug in power connectors and sata connectors while it's on? i'm guessing if it does you'll need all right angle connectors, which isn't a huge deal for the ability to hide all that wiring, that's easily the ugliest cluster of wires in my case right now.

ok, i'm realizing i still have a lot of questions, so forgive me, you talked about filters in a previous post, where might they be? i think i can see where one might be for the psu under the case, possibly pulled out from the rear, are there any others or does that one extend the entire length of the mesh area at the bottom of the case?