Bong! Bong! Bong! --56K Warning!

[Naja002]

Very interesting setup. maybee i try this too. Thank you

Give it a try. Very inexpensive and very effective.....can't beat that!





Ok, after swapping some PMs with nub (@OCN) about this and other stuff I decided to make a modification to my bongs. I don't think this is exactly what nub had in mind, but this is what I've come up with. Mind you--it didn't work out quite as well as planned.....

First start with some pvc fittings and pipe, drill and bits, towel, zip ties and a few other odds-n-ends:




Cut the pipe and mount the fittings, and drill some holes. The very top holes (4x 3/32") are for a "spray" to run down the walls, the smaller holes (8x 1/16") are for wicking:





Drill another set of 1/16" holes (8x) a little further down:




I drilled a single 1/16" hole into each cap just so the water in the bottom part of the tube would not get stagnant:




Cut the terry cloth towel to fit. Zip tied it below the top spray holes and over the first set of wicking holes:




The tubes/wicking will extend all the way down to/past the fan input area:




Here's a vid of the function. Too many holes and too big. If I would have used less holes and smaller top spray holes--this would have turned out better:



Live and learn. I may fix it, but I'm not really in the mood right now. I have to shut down the rigs et al in order to work on it.